Question regarding MX019 for FutureKit
0 views
Skip to first unread message
AseanExport.com
Jan 30, 2008, 4:56:51 AM1/30/08
to AseanExport.com
I purchased your part number MX019, Digital Tachometer.
When the HIGH or LOW revolutions sets are reached there should be
approximate 4.4 volts at the OUT point. However, on my tachometer the
OUT voltage is only 2.2 volts. How can I increase the OUT voltage to
4.4 volts?
When you turn off power, the HIGH and LOW values are RESET. How can I
turn off power to LEDs and infra-red sensor but keep my HIGH and LOW
set values?
Thank you
Greg
When the HIGH or LOW revolutions sets are reached there should be
approximate 4.4 volts at the OUT point. However, on my tachometer the
OUT voltage is only 2.2 volts. How can I increase the OUT voltage to
4.4 volts?
When you turn off power, the HIGH and LOW values are RESET. How can I
turn off power to LEDs and infra-red sensor but keep my HIGH and LOW
set values?
Thank you
Greg
ASEANExport.com Customer Care
Feb 1, 2008, 5:16:33 AM2/1/08
to Asean...@googlegroups.com
Hello Greg,
Your question was posted on my company forum. The technician should
answer your question directly on the forum within 3 days.
Please check back to the site for an answer.
Regards,
Matt Penn
Customer Service Representative
Official Site: http://www.ASEANExport.com
EBay user ID: exotic.trading
Amazon user ID: www-aseanexport-com
Overstock user ID: aseanexport
Reply all
Reply to author
Forward
0 new messages