Why wont this Makerbot work? Cupcack krumbles and Thingomatic mayhem mania.
4 views
Skip to first unread message
Sam choy
Aug 23, 2011, 8:54:00 AM8/23/11
to Additive orifice printing pose
Works Makerbot keeps giving me a tool head error 0 message. Doubt its
the toolhead since the two resisters read 1.5 ohm resistance and the
thermocouple reads intelligible output when plugged into a working
Makerbot. I suspect something is astray in the motherboard or
controller department. It only goes down when control panel commanded.
the toolhead since the two resisters read 1.5 ohm resistance and the
thermocouple reads intelligible output when plugged into a working
Makerbot. I suspect something is astray in the motherboard or
controller department. It only goes down when control panel commanded.
Sam choy
Oct 19, 2011, 4:06:01 AM10/19/11
to Additive orifice printing pose
Ok So both the makerbots at USYD are working now. The Z screw was only
going down because of a bad connection in the cable running to the
stepper motor. The motherboard and controller board were replaced and
things are dandy. The bots even have LED lights now.
going down because of a bad connection in the cable running to the
stepper motor. The motherboard and controller board were replaced and
things are dandy. The bots even have LED lights now.
Reply all
Reply to author
Forward
0 new messages