Problems updating to Repetier .92 firmware on davinci 2.0a.

[Casey Sowers]

I am new to coding and pretty new to 3d printing as i have only been doing it for about a year.  I bought without knowing a davinci 2.0a printer that the company was out of bussiness and i could no longer buy filament for the system.  My only option was to update to repetier .92 and I could use any filament and access the whole system since it was open source.  Everything worked fine till i bricked it and cant find out why.  It communicates with repetier host about what temp it is and was version it is but nothing else works.  I know it is the correct firmware I have rechecked and found only this firmware works.  I have used ai to find out wear the display options were in the code and tried a few things there but nothing either.  Just any help before i trash it and make it a filament dryer.

[Kurt The 3D Printer GUY!!]

I found a webpage & an older support email address:

Service by EKKO end on 2024/12/31.
Limited support via xyz3ds...@gmail.com

This was the webpage:   XYZprinting

I know it's probably not very helpful. 

Also - did this search and got some potentially viable results you might want to look into:

     davinci 3D Printer support forums - Search

-K

[Kurt]

Also - I'm glad you reposted & gave the thread a proper Subject line. 

FYI - reason for the links, it's mainly a backup in case folks here don't respond - since I only know of ONE person in this forum that has or Had a Davinci printer!

-K

[Casey Sowers]

I found out what was missing from the flashing because of the link you did share thanks so much.  The printer is now running repetier .92 and working fine.  

[Kurt The 3D Printer GUY!!]

That is Excelent news indeed! I'm glad I was able to help point you in the right direction.  

I'm still curious. This is a multicolor printer - am I right??

-K