Prusa XL 6.0 alpha firmware

[Murphy]

Holy moly! I loaded the new XL firmware with the phase stepping update and ran the calibration. I didn’t think much of the XL’s noise levels before because the print quality was still very high but wow, after loading the new 6.0 firmware my 2H XL is almost dead silent. 

https://github.com/prusa3d/Prusa-Firmware-Buddy/releases/tag/v6.0.0-alpha

[Dan Flemming]

You think that means the currents were way out of wack?

Suprised it didn't cause damage to the steppers.

On Tue, Mar 5, 2024, 10:56 AM Murphy <mrmurphy...@gmail.com> wrote:

Holy moly! I loaded the new XL firmware with the phase stepping update and ran the calibration. I didn’t think much of the XL’s noise levels before because the print quality was still very high but wow, after loading the new 6.0 firmware my 2H XL is almost dead silent. 

https://github.com/prusa3d/Prusa-Firmware-Buddy/releases/tag/v6.0.0-alpha

--
You received this message because you are subscribed to the Google Groups "3D Printing Tips and Tricks" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 3d-printing-tips--...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/3d-printing-tips--tricks/2891c548-08d5-46f8-b5c1-62cfb7f4766an%40googlegroups.com.

[3D Printing Tips and Tricks]

If they changed stepper current it will eventually show unless of course the currents were too high to begin with.