Joel Telling’s H2C review (3D Printing Nerd)

32 views

Skip to first unread message

Bryan Eckert

unread,

Nov 18, 2025, 11:08:42 AM (11 days ago) Nov 18

to 3D Printing Tips and Tricks

Essentially:

Prints absolutely amazing prints (the treasure chest print at the end is amazing). PLA, PETG, ABS all look fantastic.

Bed heater absolutely sucks, crazy temperature swings across the bed. He really rips Bambu on that.

Build plate is slightly smaller than the H2D/H2S and less vertical build space.

He had a nozzle clog, and in attempting to heat and unclog the nozzle, it destroyed the magnets the hotend sticks to the Vortek rack with. So, spare nozzles a must (fortunately Bambu nozzles are historically inexpensive)

He loves the hotend changer, but doesn’t give any comparisons to the single nozzle machines in regards to time saved, but does mention one print would have taken nearly an entire kg of waste without the Vortek.

$2399 for the AMS combo (wow less than I thought)

I may spring for one if the bed heating issue is addressed (H2D had a similar issue I believe)