Error in CPU code

[Manas Sahu]

Dear sir, we are getting the following error after running our code...


Loading device for application Rf_Device from file '3s2000.nph' in environment C:\Xilinx\10.1\ISE.
FATAL_ERROR:PersonalityModule:baspmdlm.c:168:1.27 - dll library <RfVirt2_Facade> does not exist.   Process will terminate. For technical support on this issue, please open a WebCase with this project attached athttp://www.xilinx.com/support.

Process "Synthesis" failed


After we Googled this we got these solutions, which didn't do us any good.

Solution 1

This issue is caused by a bad installation of ISE Design Suite 11.x. Reinstalling ISE Design Suite 11.1 and the corresponding 11.x update solves this problem. Make sure the hard disk drive where you install ISE Design Suite 11 has enough free space.

Refer to Xilinx Answer 32488 for more information about required disk space for tools installation.



Solution 2

This issue can also occur if IBM Rational ClearCase is used to check in/out ISE installation directories.  ClearCase may add folder structures within the /bin and /lib folders within an ISE Design Suite installation which may corrupt the installation.  Either do not install ISE Design Suite within a ClearCase folder, or contact ClearCase Support for further support.

ClearCase is not tested or supported with Xilinx ISE tools.

I have mailed our code to you at dsllab2012 address..

Please help.

[Kamal Kishor Pal]

@Manas:

Try 2 run your code on some other PC/laptop. You can also try 2 synthesize your code in some other version of ISE.

If the same error occurs, we wl try 2 sort it out in next lab!!

--
Regards,

Kamal Kishor U.Pal

Mobile : +918010566906 / +919211330346

http://www.linkedin.com/in/kamalkishorpal