14Point7

Power-up Voltage Test Sensor can be connected or disconnected. Disconnect all devices connected to

Have you tried anything yet? Maybe you could post what you have done and we could help.

I am making test with 10k resistor between terminal 3 and terminal 4 of the sensor connector. After

I have same problem... any answer yet? On Saturday, December 12, 2020 at 1:10:44 PM UTC-8 Hugo

is there a diagram for setting up the wiring with a CAN connector?

I sorted the serial coms.. needed to add a LF command at the end of each serial string for it to work

Follow up, given we've gotten zero response here... I tried a new sensor. Seems to have resolved

I think I damaged the temp indicator LED when I soldered it into my wiring harness. Can someone

I discovered that my voltage regulator had failed and that I was running 18+ volts. Would this damage

I have a Ms3pro Evo with a Spartan 2 controller...new setup. The wideband controller is powered by

Finally got it today and built it and the cables it's great. I was able to use my miniprog 3 to

Will be using Spartan 2 on my dyno project. I want to power it with a power adapter. What is your

Now that there is a 14point7 dropdown in TS do we still need to do that procedure? https://www.

I have SLC Free 2 with new LSU4.9 sensor. The sensor is about 20 inches from three exhaust ports on a

I'd take a pre-order form at this point...never had this much trouble giving money away! On

I have replaced the sensor with a genuine Bosch LSU4.9 part. The display is now steady but cycles

Hi! Not actually! The project's goal is to integrate the Arduino programming with Matlab and

Ok, I think I know how to get the O2 % from the lambda value. Here it goes: % O2 in dry gas = 12.5 (

Hi, please can someone confirm if the LSU4.9 versions of SLC respect the progressive warm-up ramp

Looking into some boxes I have not opened in ages, I found out I had bought a JAW 1.03 probably

As my question states i really want to have either the SLC 2 or the new version if there is anything

Hi Dave, The Romraider open source logger will request the serial data from the Nano 3. The

Hello, I did some tests that the company told me and spartan2 is fine, the problem is that the probe

I spent a long dang time trying to figure out how to reply to a question on here, it seems this site

Hey my Spartan 2 controller is cutting out after a while of driving, so that the Lambda reading stays

Good evening gents, I have this MX5 to tune. It is equipped with a Speeduino ECO, and an SLC OEM

Hello, I connected my device on my ECU and I have 2 questions: - The LSU warms up but the LED blinks

Thanks Jerald. I was hoping there would be some basic parameters to guide the selection of compatible

I've also asked this question but did not receive any answer. In my case I don't have the

Great! Thank you for confirming Alan! On Tuesday, January 12, 2021 at 10:26:59 AM UTC+8 toa...@gmail.

When used as the input to a Microsquirt, is it possible to also get a AFR signal of some sort from

Can you send me an email, it is listed on my 14point7.com website. On Wednesday, October 21, 2020 at

Please send me an email, available from my 14point7 website. On Thursday, November 19, 2020 at 11:08: