Using a vector in a bar graph

Showing 1-1 of 1 messages
Using a vector in a bar graph Andrew Hardy 7/30/12 7:56 AM

I have a collection a values in each network node module.  But each
value does not pertain to a distinct omnet module.

I want to present these values in a bar graph where there will be a
number of bars at each module along the x axis.

I have stored these values in a cOutVector which is a member of each
network node module.  I realise the cOutVector
is generally used for timed data but I could not see how else to store
it that would be accessible through the graphing tools.

I cannot find a way to present this vector as a bar graph for each module.

I realise this may not be the right way to achieve this, but if any one
has any ideas it would be appreciated.

Important Notice: the information in this email and any attachments is for the sole use of the intended recipient(s). If you are not an intended recipient, or a person responsible for delivering it to an intended recipient, you should delete it from your system immediately without disclosing its contents elsewhere and advise the sender by returning the email or by telephoning a number contained in the body of the email. No responsibility is accepted for loss or damage arising from viruses or changes made to this message after it was sent. The views contained in this email are those of the author and not necessarily those of Liverpool John Moores University.