I looked at the CNC tonight. I found 2 wires swapped on the bad channel. So it should work now. I didn't test it since I didn't remember how to start the software and run it.
It should work but verify the direction is correct.
- Jeff
--
You received this message because you are subscribed to the Google Groups "tcmaker" group.
To unsubscribe from this group and stop receiving emails from it, send an email to tcmaker+u...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
To unsubscribe from this group and stop receiving emails from it, send an email to tcmaker+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
--
You received this message because you are subscribed to the Google Groups "tcmaker" group.
To unsubscribe from this group and stop receiving emails from it, send an email to tcmaker+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.