Thought experiment. The Taz printer

13 views
Skip to first unread message

Darryl Adams

unread,
Jul 22, 2016, 5:27:33 PM7/22/16
to Robots & Dinosaurs
I am going to be running later today due to mum needing last minute doctors appointment, but where do we (if we do at all) setup the lulzbot?

My idea is to clear the Felix off the table and setup. I can use the default software or configure Matter Control. And we can run multiple instances so we don't need another station up there.

On a related note the Taz is 3mm filiament?

James Campbell

unread,
Jul 22, 2016, 8:08:08 PM7/22/16
to sydney-h...@googlegroups.com
I'm heading to the space today, i'll bring some 3mm just in case

 
 
James Campbell
Sydney Mayor Australia
 
  
 
0435493711
sydney...@gmail.com
Sydney_Makers
 
  
 
3D HUBS
 
 
 
 
 
 
 
FacebookTwitterCheck out 3D Hubs Talk, our online community for everything about 3D Printing.
 
 
 


--
You received this message because you are subscribed to the Google Groups "Robots & Dinosaurs" group.
To unsubscribe from this group and stop receiving emails from it, send an email to sydney-hackspa...@googlegroups.com.
To post to this group, send email to sydney-h...@googlegroups.com.
Visit this group at https://groups.google.com/group/sydney-hackspace.
For more options, visit https://groups.google.com/d/optout.

kris

unread,
Jul 23, 2016, 3:45:00 AM7/23/16
to sydney-h...@googlegroups.com
just looked at the shippinig docket.
2.85mm filament.
Reply all
Reply to author
Forward
0 new messages