I have another question, let say I need to finished FAST some small
walnuts and oaks part. This is what I planned to do: I will apply the
parts with Tung oil mixtures (50% Tung oil 50% paint thinner) and wipe
all excess oil. It should dry in an hour, sand lightly with #0000
steel wool. Apply first coats of Polyurethane, wait for 24 hrs sand it
again before applying another coat of polyurethane and so on until I
get the finishes I need.
My question, can I speed up the process if I apply a heat gun
(carefully) on the parts to increase the temperature? What would you
do to speed up the process rather than waiting 24 hrs according to
instruction from Woodcraft's 100% pure Tung oil? I may apply three
polyurethane coats or more that depend on the finished.
My garage temp for this time of the year is about 30 degrees to 50
degree and humidity below 50%. I could do leave the parts in the
house, temps from 68 to 70 degrees and humidity 1/2 setting. Your
advice most appreciated.
Thank you everyone
"BlueDude" <Blue...@nomanland.com> wrote in message
news:41b7a4bf...@news.individual.net...
Screw 'em. 23 hours is plenty.
>
> My garage temp for this time of the year is about 30 degrees to 50
> degree and humidity below 50%. I could do leave the parts in the
> house, temps from 68 to 70 degrees and humidity 1/2 setting. Your
> advice most appreciated.
Garage is way to cold for any oil finish that I'm aware of. This time of
year I brink my projects into the house and wait overnight to apply finish.
Ed
Unless someone here has got a really good trick, I'd suggest just
using something else. Tung Oil takes forever and a day to dry, even
in warm weather. Try one of the "natural" stains, they dry really
quickly, and look almost as good, IMO.
Aut inveniam viam aut faciam
A couple of tips - a little bit goes a long way. I'll use a capfull
added to a quart of finish (pure oil, oil and thinner mixed, or with or
without stain).
Don't mix more than you'll need, and don't re-mix any unused stuff with
your stockpile of finish.
One last thought ... you can also apply a spit coat of shellac over the
uncured tung oil. This will seal the oil (and smell) until it cures,
and makes a decent bond with any varnish (poly or otherwise) or top
coat.
Here's another alternative... if you're going to top coat with poly
anyway, then why not use a Sam Maloof finish and try a 50/50 mix of
tung oil and oil-based poly varnish? Apply it as you would the tung oil
... first coat thinned 50% with thinner ... just wipe it on (and wipe
the excess off). Repeat in 24 hours, and repeat THAT as necessary.
After about 3 to 5 coats, you'll start to building a finish. You can
then apply your poly straight until you build the finish you're looking
for.
best regards,
-Michael
George
"BlueDude" <Blue...@nomanland.com> wrote in message
news:41b7a4bf...@news.individual.net...