I have recently purchased a new SawStop 3HP Professional cabinet saw. I am still working on integrating into my shop and I’d like to ask other SawStop owners their opinion on a change I’d like to make.
I have a cyclone dust collection system and have hooked the saw to that ductwork. The ductwork in my shop requires that connection to be longer than I’d like with additional bends and long flex hose, all things that reduce collection efficiency.
I wish to relocate the dust port on my saw. Currently, it is on the rear of the saw and I wish to move it to the right side, near the back. It will clear the tool holder on the side and the mobile base. Looking inside, there is a 4” flexible hose from the blade shroud to the dust port that moves when you raise/lower the saw and when you tilt. Moving the port will not stress this hose nor change its performance (in my judgement).
I asked this question to Sawstop and received the following reply:
Thank you very much for your patience with your question earlier regarding moving the dust collection port to the right side of the cabinet. Service emailed me back and said they don’t recommend you making that modification on your saw, but it won’t necessarily void your warranty. It might be best if you contact our Service Department directly at
503-582-9934 or email them at
ser...@sawstop.com. Let me know if you need further assistance.
I contacted service department directly, but got no better answer.
So, to recap, I wish to move the port to the right side. This is to get a shorter run with less bends in my dust collecting system and to allow me more options in making a outfeed table with storage underneath for the rear of the saw.
Does anyone see any down side to moving the port?
Thanks,
Bill Leonhardt