I just heard from the owner again today.
55x21x12 XYZ He thinks. That is big for me. Would be bigger than any
job I have done or had a quote request for. I get quote requests for
specific 14x14 plates fairly often. It would sure be nice to throw a
couple plates on the table and walk away.
4 or 5K spindle he says, but it has a FREQROL spindle controller that I
think is setup for 11K if I understand the pictures correctly. Has a
low gear for tapping. I suspect 4-5K may be in low gear.
Says the old owner told him (he bought a shop that includes this
non-working machine) they had to use a 15K forklift to move it. It
looks big, so I can believe its heavy.
The control console says Dynapath, and inside the cabinet is a cover
over "something" with data that says Dynapath, but the lower part of the
cabinet has an array of boards that look a lot like the Randtronics
boards I jerked out of the Hurco and eventually threw away.
I have to be honest though. I would probably gut it out and retrofit it
to something newer and easier for me to understand and service.