Exporting MaxEnt GUI outputs for Boyce Index in R

[Marina FP]

Hello, 

I posted this question under an older thread but wasn't sure if people would see it there, so I am re-posting as a new topic. 

I was wondering the quickest way to pull outputs from the MaxEnt GUI program into R for use in calculating the Boyce Index? I have run all my SDMs through  the GUI interface and now need to calculate the Boyce Index in R. I have run the models with 10 replicates if that affects the answer. 

Thank you for advice with this inquiry. 

Best-Marina

[Alaaeldin Soultan]

Hi Marina,

Maxent normally gives an average output raster layer for the replicated model.

So all what you need to do is to use this average layer and run and you presence points to run the Boyce index.

I hope it helps

Alaa

--
You received this message because you are subscribed to the Google Groups "Maxent" group.
To unsubscribe from this group and stop receiving emails from it, send an email to maxent+unsubscribe@googlegroups.com.
To post to this group, send email to max...@googlegroups.com.
Visit this group at https://groups.google.com/group/maxent.
For more options, visit https://groups.google.com/d/optout.

--

Alaaeldin Soultan
PhD candidate
MaxPlanck Institute for Ornithology
Am Obstberg 1
78315 Radolfzell, Germany
Tel: +49 (0)7732 1501 35
Mob.+4915757474779