Installing Alu-X-Ends

314 views
Skip to first unread message

Joe Soap

unread,
Aug 8, 2014, 9:16:02 AM8/8/14
to make...@googlegroups.com
I have just received Carl's Alu-X-Ends. Before I dive in and do the replacement I wondered if anyone had any useful nuggets of information that they learnt when they upgraded their 2X.

Waltermixxx

unread,
Aug 8, 2014, 9:42:24 AM8/8/14
to make...@googlegroups.com
Did you check out Scott JD's video's on Youtube?


install video for x-ends :)

Robo

unread,
Aug 8, 2014, 10:19:01 AM8/8/14
to make...@googlegroups.com
Make sure you have the Y belt clips screwed in to the tops of the X-ends (lightly) before you put the gantry back in the machine. If you forget you'll end up having to take it all out again to put the clips on.  Also make sure you have a 5.5mm wrench/spanner before you begin disassembling things.

Joe Soap

unread,
Aug 8, 2014, 11:05:49 AM8/8/14
to make...@googlegroups.com
Yes. I have watched all of Scott's videos.
> --
> You received this message because you are subscribed to the Google
> Groups "MakerBot Operators" group.
> To unsubscribe from this group and stop receiving emails from it, send
> an email to makerbot+u...@googlegroups.com
> <mailto:makerbot+u...@googlegroups.com>.
> For more options, visit https://groups.google.com/d/optout.

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com

Reply all
Reply to author
Forward
0 new messages