Illegal Instruction

[Manu Bonxi]

Hello, my problem.. :-(

Raspberry P1 model B+ V1.2   +  Debian Jessie + RTL-USB Conceptronic CTVDIGUSB2

My copy xterm:

pi@raspberrypi:~/gqrx-2.6-rpi2-1 $ ./setup_gqrx.sh
Setting up gqrx for user pi
mkdir: se ha creado el directorio «/home/pi/.volk»
«/home/pi/gqrx-2.6-rpi2-1/data/volk_config» -> «/home/pi/.volk/volk_config»
«/home/pi/gqrx-2.6-rpi2-1/data/airspy.rules» -> «/etc/udev/rules.d/airspy.rules»
«/home/pi/gqrx-2.6-rpi2-1/data/fcdpp.rules» -> «/etc/udev/rules.d/fcdpp.rules»
«/home/pi/gqrx-2.6-rpi2-1/data/fcd.rules» -> «/etc/udev/rules.d/fcd.rules»
«/home/pi/gqrx-2.6-rpi2-1/data/hackrf.rules» -> «/etc/udev/rules.d/hackrf.rules»
«/home/pi/gqrx-2.6-rpi2-1/data/rtl-sdr.rules» -> «/etc/udev/rules.d/rtl-sdr.rules»
«/home/pi/gqrx-2.6-rpi2-1/data/sdriq.rules» -> «/etc/udev/rules.d/sdriq.rules»
pi@raspberrypi:~/gqrx-2.6-rpi2-1 $ ./run_gqrx.sh
Starting gqrx...
./run_gqrx.sh: línea 18:  1390 Instrucción ilegal     gqrx $1 $2
pi@raspberrypi:~/gqrx-2.6-rpi2-1 $

Best Regards

[Lloyd Brown]

It sounds like you're running on a RPI earlier than RPI2.  The binaries available are compiled for RPI2 and RPI3.  Most likely they included some processor-level instructions that aren't available for the RPI1's processor.

Even if that weren't the case, though, I seriously doubt that a RPI1 would have enough processing capacity to handle GQRX at any reasonable speed.

Lloyd

--
You received this message because you are subscribed to the Google Groups "Gqrx SDR" group.
To unsubscribe from this group and stop receiving emails from it, send an email to gqrx+unsubscribe@googlegroups.com.
To post to this group, send email to gq...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/gqrx/e2629500-6376-4f77-b26b-e14217da328d%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

[Aoife Hegarty]

I am getting the same problem on Raspberry pi B+, It is a RPi2, and is only a couple of months old :(  My device is an RTL-SDR.