Boblight sends only zeros

[l.m...@seznam.cz]

I made the simle circuit with Arduino connected to Linux with boblight. But when is boblight running it sends zeros only, communication between Arduino and boblight works properly:

(InitLog) start of log /home/tata/.boblight/boblightd.log
(PrintFlags) starting boblightd
(CConfig::LoadConfigFromFile) opening /etc/boblight.conf
(CConfig::CheckConfig) checking config lines
(CConfig::CheckConfig) config lines valid
(CConfig::BuildConfig) building config
(CConfig::BuildConfig) built config successfully
(main) starting devices
(CClientsHandler::Process) opening listening socket on 127.0.0.1:19333
(CDevice::Process) AmbiLight: starting with output "/dev/ttyUSB0"
(CDevice::Process) AmbiLight: setting up
/dev/ttyUSB0 write: aa 55 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
/dev/ttyUSB0 write: aa 55 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
(CDevice::Process) AmbiLight: setup succeeded
/dev/ttyUSB0 write: aa 55 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
/dev/ttyUSB0 write: aa 55 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
/dev/ttyUSB0 write: aa 55 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00

[Bob van Loosen]

Well yes, there is no client running, you have to start a client like
boblight-X11.

Bob.