can not port ics 4.0 on bb xm

18 views
Skip to first unread message

Nital Patel

unread,
Oct 2, 2014, 6:15:31 AM10/2/14
to beagl...@googlegroups.com
OMAP3 Beagle board + LPDDR/NAND                                                
I2C:   ready                                                                   
DRAM:  256 MiB                                                                 
NAND:  512 MiB                                                                 
MMC:   OMAP SD/MMC: 0                                                          
*** Warning - bad CRC, using default environment                               
                                                                               
In:    serial                                                                  
Out:   serial                                                                  
Err:   serial                                                                  
Beagle Rev C4                                                                  
No EEPROM on expansion board                                                   
timed out in wait_for_bb: I2C_STAT=1000                                        
No EEPROM on expansion board                                                   
Die ID #5eca000700000000015154781801101e                                       
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk split, HB-ISO)
musb-hdrc: MHDRC RTL version 1.400                                             
musb-hdrc: setup fifo_mode 4                                                   
musb-hdrc: 28/31 max ep, 16384/16384 memory                                    
USB Peripheral mode controller at 480ab000 using PIO, IRQ 0                    
Net:   usb_ether                                                               
Hit any key to stop autoboot:  0                                               
mmc0 is current device                                                         
gpio: pin 173 (gpio 173) value is 1                                            
gpio: pin 7 (gpio 7) value is 0                                                
SD/MMC found on device 0                                                       
reading uEnv.txt                                                               
** Unable to read file uEnv.txt **                                             
reading zImage                                                                 
** Unable to read file zImage **                                               
Booting from nand ...                                                          
                                                                               
NAND read: device 0 offset 0x280000, size 0x400000                             
 4194304 bytes read: OK                                                        
Bad Linux ARM zImage magic!          

Maxim Podbereznyy

unread,
Oct 2, 2014, 6:27:02 AM10/2/14
to beagleboard
printenv

--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups "BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.



--
Reply all
Reply to author
Forward
0 new messages