Print bed coating

[Zak Smolen]

Just tried to print something and a few minutes in I looked over and saw this:

[Zak Smolen]

Just noticed that Steve sent out an email about this earlier so disregard mine!

Sent from my iPhone

> On Dec 17, 2016, at 8:32 PM, Zak Smolen <zaks...@gmail.com> wrote:
>
> Just tried to print something and a few minutes in I looked over and saw this:
>

> --
> You received this message because you are subscribed to the Google Groups "Asheville Makers" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to ashevillemake...@googlegroups.com.
> To post to this group, send email to ashevil...@googlegroups.com.
> For more options, visit https://groups.google.com/d/optout.
> <image1.JPG>
>
>
> --
> You received this message because you are subscribed to the Google Groups "Asheville Makers" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to ashevillemake...@googlegroups.com.
> To post to this group, send email to ashevil...@googlegroups.com.
> For more options, visit https://groups.google.com/d/optout.
> <image2.JPG>
>
>
> I'll hold off on printing for now until we can look into this further. I smoothed down the coating while the bed was still hot but that was a giant bubble covering about half the bed and the coating actually expanded up a few mm at the peak of the bubble.
>
> I think it may be time for a new coating sheet...
>
> --
> You received this message because you are subscribed to the Google Groups "Asheville Makers" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to ashevillemake...@googlegroups.com.
> To post to this group, send email to ashevil...@googlegroups.com.
> For more options, visit https://groups.google.com/d/optout.