Elliott Omnimill 00

[Larry Maas]

This is the X axis power feed on an Elliott 00 Omnimill. The feed rate is changed by removing the cover and changing two spur gears. But even though I understand feed rates in inches per minute, I'm not able to understand the chart here. Hoping some of you large brain fellows might be able to figure this out. I have no manual so I'm going blind here, no info so far on my net search. 

http://www.lathes.co.uk/elliott-omnimil-00/page2.html

[Larry Maas]

OK, now I feel really stupid, looked at it again, it made perfect sense, not sure why it didn't when I tried to figure it out before. 

[David Wrate]

We’re here to help :)

--
You received this message because you are subscribed to the Google Groups "Victoria Hobby Machinists" group.
To unsubscribe from this group and stop receiving emails from it, send an email to victoria-hobby-mac...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/victoria-hobby-machinists/d37ba79e-af5a-48ff-9d1e-63288bd6f379n%40googlegroups.com.