Urgent: Importing calibrated parameters to Editor for climate scenarios

[Carli van Zyl]

Hello all,

I am trying to run future climate scenarios with my calibrated model via the Editor (I need to input additional point sources for each climate scenario and visualise the output in QGIS, so the Editor seems the best way to do this).

I calibrated in RSWAT (I don't have access to Toolbox at this time). I read somewhere that you can copy and paste the calibration.cal file from your calibrated model into the Default TxtInOut folder and then run the model from the executable file.

However, I am not sure if this would then be able to visualise the output for QGIS. So far, this is my guesstimate workflow:

1. Set up the future climate scenario with new point source in Editor and Run the model.

2. Copy my calibrated calibration.cal file into this new Default txtinout folder.

3. Run model from executable in Default txtinout folder.

4. Default txtinout scenario is now updated with new parameters.

5. Here I am uncertain. If the Default txtinout folder changed, did this also update the Default scenario values in the Editor? If so, must I run the model via Editor again to get the new Results folder for QGIS?

Thanks in advance for any help!

- Carli

[Chandu Palakuri]

Hai, 

Do you find any solution for this please share me. 

Thankyou

[Chandu Palakuri]

Thank you so much for your reply.. 

--
You received this message because you are subscribed to the Google Groups "SWAT+ Editor" group.
To unsubscribe from this group and stop receiving emails from it, send an email to swatplus-edit...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/swatplus-editor/9a8c419b-3137-42f2-8567-db1abd4c5839n%40googlegroups.com.