Sensitivity Analysis and Debug Executable Error

[Emily Blue]

Hello everyone.

I have been working with SWAT+ Toolbox and recently ran into two issues that I cannot resolve. First, when I attempt to run a sensitivity analysis, the Toolbox crashes. From the error messages, it seems related to parameters being out of bounds. However, I am using the default parameter ranges directly from the SWAT+ Editor, so I am not sure why this is happening.

To further investigate, I tried running the debug executable. I would greatly appreciate your guidance on how to resolve these issues so I can proceed with my sensitivity analysis and model calibration. 

[Celray James]

Seems related to malformed file.cio, do you mind sharing your project?

[Nancy B. Sammons]

Emily: 

Note:  The snapshot indicates you are running the executable program from the SWAT (not SWAT+) model.   Revision 695 is a SWAT version. 

Nancy

--
You received this message because you are subscribed to the Google Groups "SWAT+ Toolbox" group.
To unsubscribe from this group and stop receiving emails from it, send an email to sptoolbox+...@googlegroups.com.
To view this discussion, visit https://groups.google.com/d/msgid/sptoolbox/df1a5c6e-d0d1-4fee-8c48-75265ce8cc50n%40googlegroups.com.

[Celray James]

Actually refer to Nancy's has a very important Observation. You can only use SWAT+ Toolbox with SWAT+ not the Legacy SWAT

[Emily Blue]

Hi Nancy,

Thank you for pointing that out. I actually set up and ran my model using SWAT+ and the SWAT+ Toolbox, but after I encountered the error, I tried to locate the SWAT+ debug executable on the website. Since I wasn’t able to find it, I ended up using the regular SWAT executable (Rev. 695) instead.

Could you please let me know where I can find the correct SWAT+ debug executable for troubleshooting?

Thanks so much for your help.

[Emily Blue]

Hi Celray,

Thank you for pointing that out. I actually set up and ran my model using SWAT+ and the SWAT+ Toolbox, but after I encountered the error, I tried to locate the SWAT+ debug executable on the website. Since I wasn’t able to find it, I ended up using the regular SWAT executable (Rev. 695) instead.

Could you please let me know where I can find the correct SWAT+ debug executable for troubleshooting?

Thanks so much for your help.