Configuring of Tuya Door Sensor

[Kyaw Htoo Lin, Benjamin]

Hello, 

I have managed to flash Tasmota to my door sensor. I flash using Tasmotizer and unlike other device, this does not connect to internet after reset. 

May i know how do i proceed to setup the configuration. 

attached is the link where i follow the instruction. 

https://templates.blakadder.com/TYMC-1.html

and under configuration section, i need to enter ,

SerialSend5 55AA000200010002 

May i know how do i go about doing it?

 

[Philip Knowles]

You need to use terminal software to send the command over serial to keep it awake long enough to set the wifi configuration.

Regards

Phil K

Get Outlook for Android

---

From: sonof...@googlegroups.com <sonof...@googlegroups.com> on behalf of Kyaw Htoo Lin, Benjamin <hto...@gmail.com>
Sent: Thursday, December 31, 2020 4:43:58 PM
To: TasmotaUsers <sonof...@googlegroups.com>
Subject: Configuring of Tuya Door Sensor

 

--
You received this message because you are subscribed to the Google Groups "TasmotaUsers" group.
To unsubscribe from this group and stop receiving emails from it, send an email to sonoffusers...@googlegroups.com.
To view this discussion on the web, visit https://groups.google.com/d/msgid/sonoffusers/329725d6-91eb-43e8-ac01-8e2f57379ae0n%40googlegroups.com.

[Graham Morris]

I suscessfully flashed a few, similar to these, using a serial connection. However I did find some would not 'take' the config I sent via serial. Those ones restarted with their own Access Point, with tasmota as part of the broadcast name. I just connected to them and changed the config information direct in the web page.