Output images matching the parameters

[Sydney Winokur]

I have been running scans through the ROAST program but the images haven't matched the parameters I've been putting in. For example this is what I've been entering in ROAST:

roast('example/sydney_roast/N002/N002.nii'),{'Cz',2,'Fp2',-2},'elecType','pad','elecSize',[50 50 3],'simulationTag','Cz_N002'

But after running the program I've been getting results such the images I've attached. I cannot seem to figure out where I have gone wrong and why they don't seem to match what I have put in. Anyone have any advice or experienced this before. 

Thanks,

Sydney

[Yu (Andy) Huang]

The example you provided has a simulation tag of Cz_N002, but the figure you attached shows a simulation of tag 20241115T111210. That's why they don't match.

Hope this helps.

--
You received this message because you are subscribed to the Google Groups "roast-users" group.
To unsubscribe from this group and stop receiving emails from it, send an email to roast-users...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/roast-users/bdc079f8-e16c-4178-9da1-0da6cf0d994fn%40googlegroups.com.

[Sydney Winokur]

Those are the images that were produced when I input those parameters, nothing else was outputted or has that stimulation tag 

[Yu (Andy) Huang]

You can delete all the output under your data folder and rerun it. 

To view this discussion visit https://groups.google.com/d/msgid/roast-users/9cd224dd-76a8-4b5b-8153-4423bd7e25f1n%40googlegroups.com.

[Sydney Winokur]

I have, and I have ran brand new MRI's with the following parameters and still get images that do not match: 

roast('example/sydney_roast/p001_scan5/p001_scan5.nii'),{'Cz',2,'Fp2',-2},'elecType','pad','elecSize',[50 50 3]

[Sydney Winokur]

I figured out what the issue was. ROAST was not reading the parameters I was setting. Had to ass more brackets to ensure everything was getting read. Thank you :)