Asking for help regarding the Yamaha electric feeder (F8MM-204-1106) controlling

[Vivek Singh]

I have recently purchased a Yamaha F8MM-204-1106 feeder and I am trying to operate it with OpenPnP without using air pressure. However, I have no idea how to control it. I would appreciate any guidance or suggestions on how to set it up and control it effectively using OpenPnP.

The power connector has pins labeled as follows: 1 & 2 for optocouplers, 3 for GND, and 4 for 24V.
Any help would be greatly appreciated. Thank you!

[Mike Menci]

This feeder is not listed in OpenPnP hardware supported feeder list  Model is: YAMAHA Feeder YMH-EF8-000 SMT 
Mike

[Toàn Huỳnh]

I have used this Yamaha Feeder. You will use the Reference Auto Feeder of OpenPnP. The control circuit you will control 2 Opto pins.

Video:

https://youtu.be/m5yRQZz11qY

CÔNG TY TNHH ĐIỆN TỬ - TỰ ĐỘNG HÓA AFARCO        

-    Địa chỉ: 279 Đường ĐX-70, Khu phố 5, Phường Định Hòa, Thành phố Thủ Dầu Một, Tỉnh Bình Dương,  Việt Nam

-    Điện thoại:  0989 941 355                                   

-    Mã số thuế: 370 304 7293                                

Vào 19:04 T.6, 18 Th7, 2025 Vivek Singh <bhadau...@gmail.com> đã viết:

I have recently purchased a Yamaha F8MM-204-1106 feeder and I am trying to operate it with OpenPnP without using air pressure. However, I have no idea how to control it. I would appreciate any guidance or suggestions on how to set it up and control it effectively using OpenPnP.

The power connector has pins labeled as follows: 1 & 2 for optocouplers, 3 for GND, and 4 for 24V.
Any help would be greatly appreciated. Thank you!

--
You received this message because you are subscribed to the Google Groups "OpenPnP" group.
To unsubscribe from this group and stop receiving emails from it, send an email to openpnp+u...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/openpnp/8d95a2b8-05ae-4f56-8e9c-38bafa09077fn%40googlegroups.com.

[Chintu Gurbani]

Can you give details of control circuit to control 2 Opto pins?

To view this discussion visit https://groups.google.com/d/msgid/openpnp/CAOP%2B87K9xhKCnTJWaSkPThN-y%3DqckbK0mWkDcjPUgvTQuULsWQ%40mail.gmail.com.

[SM]

>> Can you give details of control circuit to control 2 Opto pins?

i'm using this feeders too, since six years

you could trigger it very easy with an arduino or similar, just sending an 1ms pulse to the optocoupler input

it's important, that you enable the optocoupler input in the feeder setup (see feeder manual)

[SM]

... and the original manual of this feeder

[Mike Menci]

translation of the manual; 

[Mike Menci]

And Sett up Menu works as well for you ?

[Chintu Gurbani]

This worked for me. Thanks to all