Help Wanted: GcodeDriver Users

[Jason von Nieda]

Hi all,

If you are currently using GcodeDriver, could you please send me your machine.xml along with a quick note about what controller you are using? If you could include firmware version that would be really helpful as well.

This weekend I will be adding code to GcodeDriver to make it much easier for first time users to set up, and I intend to include a couple basic Gcode profiles. I am pretty sure that I can actually just include a Generic profile and a TinyG profile, but I'd like to confirm that by collecting some examples.

Please consider taking a moment to do this. It will really help the project.

Thanks,

Jason

[spanner888]

Attached was a test configuration that did work .... on a partly built test machine with Marlin 1.1.0 RC4.

Have roughly place a few parts, need to improve feeders, lights etc ... will get back to this soonish.

Hope that helps.

[Jason von Nieda]

Thank you!

Jason

--
You received this message because you are subscribed to the Google Groups "OpenPnP" group.
To unsubscribe from this group and stop receiving emails from it, send an email to openpnp+u...@googlegroups.com.
To post to this group, send email to ope...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/328dc2c5-2c29-42fc-a2f3-627da9d0d075%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

[alex]

I use fully custom control board, so don't think the is any sense in posting config.

[Nuri Erginer]

Hi Alex,

Is it possible to share your custom controller board with us here :

https://groups.google.com/forum/#!topic/openpnp/OsJimkfRjGE

Thanks,

Nuri

 

--
You received this message because you are subscribed to the Google Groups "OpenPnP" group.
To unsubscribe from this group and stop receiving emails from it, send an email to openpnp+u...@googlegroups.com.
To post to this group, send email to ope...@googlegroups.com.

To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/c1830383-4fab-471a-a0d1-722e0cc5a68c%40googlegroups.com.

[Tom Keddie]

Hey Jason,

Finally catching up on the list of stuff left incomplete for maker faire.

I've enclosed my config.  The main change I made was to home Z before homing X and Y.

I'm using the chinese version of the smoothieboard.

Cheers,

Tom

[Jason von Nieda]

Thanks Tom!

--
You received this message because you are subscribed to the Google Groups "OpenPnP" group.
To unsubscribe from this group and stop receiving emails from it, send an email to openpnp+u...@googlegroups.com.
To post to this group, send email to ope...@googlegroups.com.

To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/5c99b7dc-4ae0-4454-9d90-3cb2c2dfe55f%40googlegroups.com.