Delivery Condition of the Plate

[williams p wilson]

Dear Experts,

Please advise about the "Delivery conditions of the Plate" required to form a 2:1 Seli Ellipse Dish Heads with respect to the below specification.

1) Material Grade = SA 516 Gr.70

2) Minimum Required Thickness of the Dish Head = 70 mm

   Actual thickness suggest by the dish head supplier = 85 mm

3) Vessel Design Pressure = -28.88 to 121.11 Degree C

4) Service = Sour 

5) Dish head prepared by Hot forming with a tem.> 11°C of NR Tem. At Mill

6) Dish head will be Normalized @ 920 Degree C Max considered after forming.

7) Normalizing holding time shall be 1-1.5 Min/mm (Mill MTC / SPWHT)

8) Dish head prepared with a single longitudinal joint.

Thank You & Regards

Williams P Wilson

QA/QC Engineer

P Please consider the environment before printing this message

[williams p wilson]

Dear Experts,

FYI

Corrected Specification No.5 = Dish head prepared by Hot forming with a tem. less than 11°C of NR Tem. At Mill

Thank You & Regards

Williams P Wilson

QA/QC Engineer

P Please consider the environment before printing this message