Penetration in rubber contact

42 views
Skip to first unread message

Osama Elshamy

unread,
Sep 16, 2026, 3:04:51 AMSep 16
to LS-DYNA2
Hello all,

I am simulating a rubber pad in between two steel plates, The steel plates are modeled using elastic steel material and the rubber is modeled using MAT_077 or MAT_181. I am using AUTOMATIC_SURFACE_TO_SURFACE_MORTAR for the interface between them with the values shown in the attached figure. The problem is that there is a penetration between the rubber and the steel. I would appreciate it if anyone could help avoiding this penetration.

image.png
Best regards,
Osama

Valery Anpilov

unread,
Sep 16, 2026, 4:10:23 PMSep 16
to LS-DYNA2
please try this
555.PNG

Osama Elshamy

unread,
Sep 16, 2026, 5:51:08 PMSep 16
to Valery Anpilov, LS-DYNA2
Hello Valery,

Thank you very much for your help. 
Is this AUTOMATIC SURFACE TO SURFACE MORTAR?

--
You received this message because you are subscribed to the Google Groups "LS-DYNA2" group.
To unsubscribe from this group and stop receiving emails from it, send an email to ls-dyna2+u...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/ls-dyna2/5c3c85db-03e6-46d2-ae36-f8ed6124e790n%40googlegroups.com.

Valery Anpilov

unread,
Sep 17, 2026, 10:10:48 AMSep 17
to LS-DYNA2
yes

Who calculated the constants for the rubber models?

Are you sure these models are suitable for your specific case?

I recommend examining the models in the PolyUMod library.

Leszek Flis

unread,
Sep 17, 2026, 1:38:12 PMSep 17
to Valery Anpilov, LS-DYNA2
Givin exoerimental curve LS-Dyba cal ulates and designate ruber cobstans automattcly and pring then in log files.


From: ls-d...@googlegroups.com <ls-d...@googlegroups.com> on behalf of Valery Anpilov <valer...@gmail.com>
Sent: Thursday, 17 September 2026 16:10:48
To: LS-DYNA2 <ls-d...@googlegroups.com>
Subject: Re: [LS-DYNA2] Re: Penetration in rubber contact
 

Valery Anpilov

unread,
Sep 17, 2026, 2:24:52 PMSep 17
to Leszek Flis, LS-DYNA2
I recommend that you familiarize yourself with the MCalibration program.

чт, 17 сент. 2026 г. в 20:38, Leszek Flis <leszek...@gmail.com>:
Reply all
Reply to author
Forward
0 new messages