Model timestep error

40 views
Skip to first unread message

OWAIS UL HASSAN

unread,
Aug 18, 2026, 8:19:08 AMAug 18
to LS-DYNA2
I’m working on an LS-DYNA model involving a stone masonry wall. When I run the model, I’m not sure why the simulation terminates after less than a second and shows only two states. I suspect that the time step is becoming extremely large (9.00E+05) or is being affected unexpectedly during the simulation.

I would really appreciate any suggestions or guidance on what could be causing this issue and how I can troubleshoot it.

initialization completed
       1 t 0.0000E+00 dt 9.00E+05 flush i/o buffers            08/18/26 17:31:59
       1 t 0.0000E+00 dt 9.00E+05 write d3plot file            08/18/26 17:31:59
 
 *** termination time reached ***
       1 t 9.0000E+05 dt 9.00E+05 write d3dump01 file          08/18/26 17:31:59
       1 t 9.0000E+05 dt 9.00E+05 write d3plot file            08/18/26 17:31:59

Евгений Калентьев

unread,
Aug 18, 2026, 9:08:16 AMAug 18
to OWAIS UL HASSAN, LS-DYNA2
One possible reason is incorrect units (dimensions). If you mix up the units (for example, entering the modulus of elasticity in Pa instead of MPa, or density in kg/m³ instead of t/mm³), the speed of sound in the material will be calculated incorrectly. Since the time step depends directly on element size and the speed of sound, the calculated step can become enormous.

Sincerely,
Eugene Kalentev

вт, 18 авг. 2026 г., 16:19 OWAIS UL HASSAN <2024r...@iitjammu.ac.in>:
--
You received this message because you are subscribed to the Google Groups "LS-DYNA2" group.
To unsubscribe from this group and stop receiving emails from it, send an email to ls-dyna2+u...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/ls-dyna2/1aa83e89-655e-4da1-9cb0-02d5c5881c91n%40googlegroups.com.


Reply all
Reply to author
Forward
0 new messages