contact between honeycomb layer and rebar mesh
Shubham Sharma
What cards shall I use to define the contact between the two?
l...@schwer.net
I googled “ls-dyna contact beam to shell edge” and received this reply:
To model contact between a beam element and a shell edge in LS-DYNA, use *CONTACT_AUTOMATIC_GENERAL, add null beams along shell edges, and include those null beams on the slave side. Standard surface contacts do not reliably track raw shell-edge to beam interactions without geometric preparation.
--len
CONFIDENTIALITY NOTICE: The contents of this email message and any attachments are intended solely for the addressee(s) and may contain confidential and/or privileged information and may be legally protected from disclosure. If you are not the intended recipient of this message or their agent, or if this message has been addressed to you in error, please immediately alert the sender by reply email and then delete this message and any attachments. If you are not the intended recipient, you are hereby notified that any use, dissemination, copying, or storage of this message or its attachments is strictly prohibited.
--
You received this message because you are subscribed to the Google Groups "LS-DYNA2" group.
To unsubscribe from this group and stop receiving emails from it, send an email to ls-dyna2+u...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/ls-dyna2/1910829d-f6e2-41b0-89da-f4bc0c23d235n%40googlegroups.com.
Ameen Topa
Check the video below, and see which option that works best for your case (beam to shell edge)
https://www.youtube.com/watch?v=KgvYHbMObso
Regards,
Ameen
To view this discussion visit https://groups.google.com/d/msgid/ls-dyna2/001701dd1e10%24e0ce7640%24a26b62c0%24%40schwer.net.