Part of Workshop and Lathe out of action

[Mark Wainwright]

HI All
We've moved the Lathe during 'Hack the Space' today, unfortunately it has un-earthed (no pun intended) some electrical issues and logistics which can't be fixed tonight. Therefore the Lathe and part of the workshop is out of action/without power.
Any sockets will not work on the rear or window wall of the workshop (from behind the bandsaw-lathe-along bench on window wall).
I will endeavour to get the power & sockets back working by lunch tomorrow and the lathe as soon as possible after that
regards Mark

[Mark Wainwright]

Hi All
All the power sockets in the workshop are now working again. We had to shuffle them in the conduit to move them out of areas where they would get covered in oil from the lathe now it’s been repositioned. They’ve also been slightly re jigged under the workshop window while we look at revamping that work bench.
I hope to do some work on the lathe tomorrow as long as I can get to the Hackspace due to the Carnival blocking off my usual route.

Kind Regards Mark

Leeds Hackspace

https://leedshackspace.org.uk

--
You received this message because you are subscribed to the Google Groups "Leeds Hack Space" group.
To unsubscribe from this group and stop receiving emails from it, send an email to leeds-hack-spa...@googlegroups.com.
To view this discussion, visit https://groups.google.com/d/msgid/leeds-hack-space/f85dd184-a492-4cf7-b385-669f31122e42n%40googlegroups.com.

[Mark Wainwright]

Hi All
Lathe is back up and running and ready for use.
there's a couple of little bits to do but these are ongoing enhancements and will only improve the lathe as they get sorted.

thanks Mark