Kate
Sounds like an interesting experiment. I'll make several comments.
Your inclusion of four covariates are likely causing you difficulty. You aren't explicit, but I suspect most or all of the covariates are factor rather than continuous. If they are all factors, then you should query your data to discover how many detections you have in each of the possible categories of covariates. Pretend you have but two levels for each of your covariates--that results in 2^4 different combinations (16). That shrinks your 100 observations per treatment down to ~8 detections per combination (assuming all combinations are equally represented). That will make for a challenging parameter estimation problem.
However, the situation is likely not that rosy. There are likely combinations that have no detections (presence of rain in the absence of cloud cover); that make the estimation problem even more difficult (likely leading to convergence failure in the estimation routine). To top it off, your covariates are likely collinear (correlation between your meteorological variables). You are also incorporating adjustment terms along with the covariates. Not a surprise that you suffer failure of model fitting.
I suggest you work with a less ambitious models. There is a section in the users guide called "MCDS analysis guidelines" that discusses these difficulties. In part, here is a portion of that section:
Fitting the detection function with multiple covariates is
significantly harder, computationally, than in the case where
there is only one covariate. This has
several consequences:
• the analysis engine takes longer to run
• the algorithm will fail to converge more often
Because of this, it is important to be careful and thoughtful when
setting up and running MCDS analyses. Here are some
recommendations:
• Rather than including numerous covariates at once, start by
including one covariate at a time, and selecting the covariate
that gives the best model fit/lowest AIC/AICc/BIC. You can then
carry out forward stepwise selection by adding one additional
covariate at a time, while retaining the one(s) already selected,
until there is no decrease in the AIC/AICc/BIC value (depending on
the criteria you are using).
• Bear in mind that factor covariates are usually harder to fit
than non-factor covariates, especially as the number of factor
levels increases (see Factor and Non-factor Covariates in MCDS
earlier in this Chapter for information on factor covariates). If
you encounter problems while trying to fit a factor covariate, try
reducing (condensing) its number of levels, if possible.
• Avoid using the feature that allows automatic selection of
adjustment terms – at least to start with. Instead, start by
using a model with no adjustments, and if this converges try one
with one adjustment. Gradually work up to more adjustments if
required.
Two final thoughts. Recognise distance sampling has the property of pooling robustness--meaning abundance estimates are unbiased even when all forms of heterogeneity in detection probability are not modelled. Another reason to simplify the detection function model. Lastly, you note you are still in the preliminary states of your analysis, have a look at this paper
--
You received this message because you are subscribed to the Google Groups "distance-sampling" group.
To unsubscribe from this group and stop receiving emails from it, send an email to distance-sampl...@googlegroups.com.
To post to this group, send email to distance...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/distance-sampling/5ff403ee-7684-4550-b3b2-50623c1a4ace%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
-- Eric Rexstad Research Unit for Wildlife Population Assessment Centre for Research into Ecological and Environmental Modelling University of St. Andrews St. Andrews Scotland KY16 9LZ +44 (0)1334 461833 The University of St Andrews is a charity registered in Scotland : No SC013532