Printing parameters

[Daniel Espejel]

Hello!
recently decided to start the construction of a cyclone, but do not have much knowledge about 3D printing.

which parameters are recommended to print the parts, quality, fill, speed?
I'm a little overwhelmed with these values to get a good result without wasting time and plastic, 3D printing is still an expensive procedure in my country

thank you

[Carlos García]

Hi Daniel, the parameters depend a lot on the printer you use.

You don't need any special setting for Cyclone's parts, just try with parameters that have worked for you in the past.

For the Witbox and Hephestos printers, the parameters are:

Material: PLA, 1.75 mm
Nozzle diameter: 0.4 mm
Layer height: 0.25 mm
Shell thickness: 1.2 mm
Bottom/Top thickness: 1 mm
Fill density: 25 %
Print speed: 60 mm/s
Printing temperature: 210 deg

Cheers,

Carlos

--
You received this message because you are subscribed to the Google Groups "Cyclone PCB Factory" group.
To unsubscribe from this group and stop receiving emails from it, send an email to cyclone-pcb-fac...@googlegroups.com.
To post to this group, send email to cyclone-p...@googlegroups.com.
Visit this group at http://groups.google.com/group/cyclone-pcb-factory.
To view this discussion on the web, visit https://groups.google.com/d/msgid/cyclone-pcb-factory/77109923-591e-471a-9a3d-b442d79856f4%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.