VDM-1 with Altair 8800 simulator

[Antonio Tamairón]

Hello.

The last weekend I test the Dazzler client with Altair Simulator and all worked fine. Today, I try to use VDM-1 client. I've prepared simulator (update firmware) to use VDM-1.

I configured VDM-1 on Native port. 

Now the configuration is:

• Map to interface: On USB Native Port
• Memory address: CC00 
• DIP switch (1)+2: off/on (normal video)
• DIP switch (3)+4: off/off (all cursors suppressed)
• DIP switch (5)+6: on/off (control characteres show, VT-CR blanking on)
• Map keyboard to: SIO

Client on windows is connected to the native port and baudrate it the same that Altair simulator.  

I try to launch "CUTER on VDM-1" but never I achieved to see ">" but  a lot of characters are shown without sense. (I tried to change memory address at C000h too, without success)

What could be happening?

Thanks in advance.

[Antonio Tamairón]

Ok.

At the end I achieve to start walking VDM-1 terminal. At the moment I follow the documentation about VDM-1 from Altair Simulator (page. 18) and all work fine.

Thanks

--
You received this message because you are subscribed to the Google Groups "Altair-Duino" group.
To unsubscribe from this group and stop receiving emails from it, send an email to altair-duino...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/altair-duino/2296cfea-2a3e-4cbb-9c72-1be002b99b3fn%40googlegroups.com.

--

Antonio Tamairón

[Walt Perko]

Hi, 

I've been running one of my Altair-Duino Pro computers as a Processor Technology Subsystem B/Sol-20 for a few years now.  

https://www.brainless.org/Altair/Altair-DuinoPro2/

I wish I could add the Processor Technology character set to a DHansel VersaTerm so I could at least use the character set on more computers.  Sadly, my eyes are too old to make the character file needed to load into the VersaTerm.  

.