y-splitter for 3D chameleon

[Thor Sten]

Hi guys.
Actually I´m setting up my 3D chameleon and and I cannot get it to run without interruptions. Sometimes the filament is stucking inside the splitter and it would be great if someone know where I can get the orgin one.
Thanks in advance.

Regards, Thorsten

[Sean]

You can find it on their Github... 6th file up from bottom of the list.

https://github.com/3DChameleon/3DChameleonMk4

> --
> You received this message because you are subscribed to the Google Groups "3D Printing Tips and Tricks" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to 3d-printing-tips--...@googlegroups.com.
> To view this discussion visit https://groups.google.com/d/msgid/3d-printing-tips--tricks/34b60b06-d897-427f-90aa-62532ea42b50n%40googlegroups.com.

[Thor Sten]

That's where I got it 😉

[markni...@gmail.com]

Thor,

If recall correctly, Andy had a go with one version of Bill Steele's 3d Cameleon.

Bill is a smart, honest, and I am told, good guy.

No one I'm aware got these working properly and consistenly.

[Thor Sten]

Everything works except the feed on the splitter. Was hard work for a working code. 

You received this message because you are subscribed to a topic in the Google Groups "3D Printing Tips and Tricks" group.
To unsubscribe from this topic, visit https://groups.google.com/d/topic/3d-printing-tips--tricks/eyAql5HO1l8/unsubscribe.
To unsubscribe from this group and all its topics, send an email to 3d-printing-tips--...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/3d-printing-tips--tricks/c606d74d-302c-4234-b835-aa2e10d1d796n%40googlegroups.com.

[markni...@gmail.com]

If I recall correctly, Bill's splitters were injection molded polycarbonate.

Lots of luck finding one unless Bill has one he will sell you: https://www.3dchameleon.com

Other than that, see the last line of my first response.