Client Mode for Softphone not visible

[Manfred Takondwa Makawa]

I recently flashed SECN-2_0_1-GA01 on Nanostation M2 Loco but under asterisk I cannot set the softphone support to client.
Is this a bug or is it because I am not using the original mesh potatoes?
The attached picture shows what I see when I go under the Asterisk config.

[T Gillett]

Hi Manfred

Softphone Client mode is only used for the MP with a built in FXS facility.

This mode allows the FXS to interoperate with softphone devices.

Regards
Terry

--
You received this message because you are subscribed to the Google Groups "Village Telco Development Community" group.
To unsubscribe from this group and stop receiving emails from it, send an email to village-telco-...@googlegroups.com.
To post to this group, send email to village-...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/village-telco-dev/63efc4cb-406f-4ec2-8f0f-9bd591cc1b09%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

[Manfred Takondwa Makawa]

So there's really no point in me turning on the Asterisk as these devices don't even have a port for me to plug an analog phone?

[T Gillett]

Hi Manfred

Asterisk is provided on these devices basically for use as a Softphone Master node if required.

If you are not using that then you are correct - there is no real point in having Asterisk enabled.

Regards
Terry

To view this discussion on the web visit https://groups.google.com/d/msgid/village-telco-dev/06710994-a5dc-45da-8c16-03c718799719%40googlegroups.com.