%MOUNT-F-WRONGVU, device is already a member of another virtual unit

[Phillip Helbig---undress to reply]

OK, I have the new shelf working, so booted up the node which is
supposed to use it. Everything OK, then the MERGE on the system-disk
shadow set runs into problems: in and out of mount verification, one
member showing an increasing error count. OK, bad disk, replace it with
a new one (which I wanted to anyway, since the fast shelf can make use
of a faster disk). I INITIALIZEd it, then get

%MOUNT-F-WRONGVU, device is already a member of another virtual unit

HELP/MESSAGE mentions three things which can cause this, BUT NONE OF
THEM APPLY IN MY CASE (regarding the second, I repeated the command
after the copy had started).

Would the MOUNT/CLUSTER work if I had created the shadow set with
MOUNT/SYSTEM then did a MOUNT/CLUSTER after the copy had started?
(However, I have certainly CREATED shadowsets with MOUNT/CLUSTER in the
past, and there was never a problem.)

[Phillip Helbig---undress to reply]

In article <isbk47$2i4$1...@online.de>, hel...@astro.multiCLOTHESvax.de

(Phillip Helbig---undress to reply) writes:

> %MOUNT-F-WRONGVU, device is already a member of another virtual unit
>
> HELP/MESSAGE mentions three things which can cause this, BUT NONE OF
> THEM APPLY IN MY CASE (regarding the second, I repeated the command
> after the copy had started).
>
> Would the MOUNT/CLUSTER work if I had created the shadow set with
> MOUNT/SYSTEM then did a MOUNT/CLUSTER after the copy had started?
> (However, I have certainly CREATED shadowsets with MOUNT/CLUSTER in the
> past, and there was never a problem.)

Will I be able to do MOUNT/CLUSTER once the shadow copy completes? Or
do I actually need a reboot?

[Phillip Helbig---undress to reply]

In article <isbkam$2rc$1...@online.de>, hel...@astro.multiCLOTHESvax.de

I tried a few times, and about half-way through the copy it mounted.