error at installation of vms 6.1

[Marcel Chenard]

We proceed in last days at installation of vms 6.1 on a Vax 4000 model 300
and received at the beginning of the last boot (during installation) the next
error message:

SYSINIT-E - error mounting system device, status = 007280B4
SYSINIT-E - error opening or mapping F11BXQP, status = 00018272

The system disk is a RF31..

Anyone has explanation about these messages???

[Jim Mehlhop]

You brought a system with it's own system disk into a cluster that
already had a system disk with the same label.

Do a conversational boot on the new system
then at sysboot prompt
SYSBOOT> show vaxcluster ! write down what is under current column
SYSBOOT> set vaxcluster 0
sysboot> continue

At $

$ set volume/label=whatever sys$sysdevice
$ mc sysgen
sysgen> set vaxcluster "whatever it was before"
sysgen> write current
sysgen> exit

$ @sys$system:shutdown !shutdown and reboot

_________________________________________________________________________
Jim Mehlhop, Support Engineer || ||
Cisco Systems || ||
JMeh...@cisco.com |||| ||||
Phone 719-638-8448 |||||||| ||||||||
Alpha Pager jmeh...@airnote.net
..:|||||||||||||||||||||:..
Pager 800-796-7363 pin 101-0442 C i s c o S y s t e m s

_________________________________________________________________________

[Vance R. Haemmerle]

In article <mchenard-120...@ailed-02.cegep-ste-foy.qc.ca>,

Marcel Chenard <mche...@cegep-ste-foy.qc.ca> wrote:
>
> We proceed in last days at installation of vms 6.1 on a Vax 4000 model 300
>and received at the beginning of the last boot (during installation) the next
>error message:
>
> SYSINIT-E - error mounting system device, status = 007280B4
> SYSINIT-E - error opening or mapping F11BXQP, status = 00018272
>
> The system disk is a RF31..
>
> Anyone has explanation about these messages???

$ write sys$output f$message("%X007280B4")
%MOUNT-F-VOLALRMNT, another volume of same label already mounted

$ write sys$output f$message("%X00018272")
%RMS-E-DNR, device not ready, not mounted, or unavailable

Are you booting this 4000/300 into a cluster? Does the volume label of
the system disk on the booting node match a disk which is already in the
cluster? Have you switched disks while other cluster members still have
the older disk mounted with the same label?

--
Vance Haemmerle
va...@alumni.caltech.edu
FS: MS42-KA 8mb memory for VS3100, $125

[Joe Pizzi]

Or, is the disk still shown as mounted on one of the other cluster members?

Regards,
Joe Pizzi <joe....@ttu.edu>