I don't think the problem is with PHD2. I just tested this on my Windows laptop using the

Forgot to add this https://openphdguiding.org/logs/dl/PHD2_logs_4TmW.zip On Saturday, July 25, 2026

TOM If you want to use Claude, try this: 1. Open PhD2 manual in a tab on browser 2. Open PhD2 logfile

I have had the GTI since pre order days (So a while). For over a year I have been trying to use PHD2

20-35ms is effectively near zero backlash. Use the guiding assistant and measure your backlash. If

I think the ZWO mounts require 'Reverse Dec output after meridian flip' to be 'On'.

It's happened to me, so I point that out. If PHD is accidentally trying to use your main camera

Hi Bob. I think we need to back up a bit and re-characterize the problem. First, your guiding is more

For random-mode dithering, each random move is relative to the current lock-point which, in turn, is

It can depend on what driver you're using - native or ASCOM - and whether it can operate in

Also, your guide camera is running in 16-bit mode which is good, but you've set your

The good news is if this is the issue, it's easily fixed. The guiding assistant run will measure

Bruce, That's the discrepancy. It clearly shows 230 s in PHD with auto adjust unchecked. But in

I just found it. I did not see that there was a drop down there. Thanks very much. Don On Sunday,

Ah! I had checked logs to see if it had been caused by a Meridian Flip but didn't see one (I hadn

It's still there, still works. If it's disabled, you are probably trying to use a

Thanks. Maybe not. Here they are again. https://openphdguiding.org/logs/dl/PHD2_logs_LWwu.zip The

Thanks for the education and reply's everybody. Jim On Wed, Jul 8, 2026 at 4:22 PM Dale Ghent

>>> Despite all that, I still can't get properly round, well-defined guide stars, round

Have you considered a second focus panel or asking RB to modify the driver? Bryan On Monday, July 6,

Hey Bruce, I agree that there probably isn't much more you can do. Thank you very much for your

Tried using open source only and make is completing successfully. On Sunday, 28 June 2026 at 3:17:38

Hi Said. I really can't see what you're worried about here. The total guiding RMS for your

Hi Richard Can you clarify your equipment setup? I assume this is an oag on some style of reflector

Thanks for the update Xavier On Sat, Jun 27, 2026 at 10:30 PM Xavier Peillon <xav.thegreenthumb@

I managed to adjust the RA gear mesh by releasing a little bit the meshing between the worm and the

> On Jun 25, 2026, at 22:38, Bruce Waddington <bw_m...@earthlink.net> wrote: > > I

In order to make any progress with this, you will need to correct a number of operational mistakes.

In order to work on this problem, I suggest doing a couple of things: 1. Increase the guide speed in

glad to hear it's working well, thanks for the update On Sun, Jun 21, 2026 at 4:42 AM Suzanne