Groups keyboard shortcuts have been updated
Dismiss
See shortcuts
Skip to first unread message
Yvan Turcotte
Nov 25, 2024, 10:22:11 AM11/25/24
to ZOOM Forum
The TWR-100 required the probe tip to be flush with the stator wall :
Unlike the previous TWR-100, if the TWR-200 is installed that way, the readings obtained will showed some noise in the signal.
To remedy this, it was found that installing the sensor half an inch into the ventilation hole helps avoid any noise on the signal
To remedy this, it was found that installing the sensor half an inch into the ventilation hole helps avoid any noise on the signal
Reply all
Reply to author
Forward
0 new messages