Unable to install COMAC.
10 views
Skip to first unread message
윤대희
Jul 26, 2021, 10:48:38 PM7/26/21
to CORD Developers, 김동국
Hello, everyone.
I am installing COMAC-IN-A-BOX by referring to the guided url. url address :
When trying to use "AUTOMATION-TOOLS", the storage locations of "INCUBATOR" and "STABLE" in "HELM-CHARTS" have changed and cannot be installed. I looked at "MAKEFILE" to modify its storage location, but I couldn't find the part where it was created. Can you tell me where to modify it?
In addition, the installation command of HELM could not be executed because there was no TILLER as I followed the manual to install it manually. So I set up KUBERNETES and HELM separately and followed the manual. There was a problem installing CORD-PLATFORM and COMAC PROFILE. There was a problem of installing LOGGING in the process of installing CORD-PLATFORM, so it was difficult to install after processing the annotation.
Then there was a bigger problem. There is no COMAC and OMEC to install in the manual on the HELM-CHART that has been copied with the "git clone" command. Because there is no COMAC and OMEC, it cannot proceed in any other way. I don't know if COMAC and OMEC are missing or replacing them with something else. Is there anyone who can provide a solution to this problem?
I am installing COMAC-IN-A-BOX by referring to the guided url. url address :
When trying to use "AUTOMATION-TOOLS", the storage locations of "INCUBATOR" and "STABLE" in "HELM-CHARTS" have changed and cannot be installed. I looked at "MAKEFILE" to modify its storage location, but I couldn't find the part where it was created. Can you tell me where to modify it?
In addition, the installation command of HELM could not be executed because there was no TILLER as I followed the manual to install it manually. So I set up KUBERNETES and HELM separately and followed the manual. There was a problem installing CORD-PLATFORM and COMAC PROFILE. There was a problem of installing LOGGING in the process of installing CORD-PLATFORM, so it was difficult to install after processing the annotation.
Then there was a bigger problem. There is no COMAC and OMEC to install in the manual on the HELM-CHART that has been copied with the "git clone" command. Because there is no COMAC and OMEC, it cannot proceed in any other way. I don't know if COMAC and OMEC are missing or replacing them with something else. Is there anyone who can provide a solution to this problem?
Reply all
Reply to author
Forward
0 new messages