Ragarding --enable-commitlog

[Aditya Kumar cs20m009]

I did this inside build directory of my riscv-isa-sim:

1) ../configure --enable-commitlog --with-isa=RV64IMAFD --prefix=$RISCV 

2)make 

3) Sudo make install

But when I am trying to run ./build.sh of riscv-tools directory, then it is again deleting the build directory of riscv-isa-sim and then again reconfiguring and building risc-isa-sim.

Could anyone please tell the detailed steps to how to do  --enable-commitlog ? I am new in this area.

Thanks and Regards,

Aditya Kumar

[Tommy Murphy]

Why are you rebuilding all of the tools?

If you need to do this then just configure your manual build of Spike to install in a separate directory and use it from there?

Alternatively edit the Spike configure command in the riscv-tools build.sh?

---

From: Aditya Kumar cs20m009 <cs20...@smail.iitm.ac.in>
Sent: Monday, October 18, 2021 2:01:24 PM
To: RISC-V SW Dev <sw-...@groups.riscv.org>
Subject: [sw-dev] Ragarding --enable-commitlog

 

--
You received this message because you are subscribed to the Google Groups "RISC-V SW Dev" group.
To unsubscribe from this group and stop receiving emails from it, send an email to sw-dev+un...@groups.riscv.org.
To view this discussion on the web visit https://groups.google.com/a/groups.riscv.org/d/msgid/sw-dev/8b3324ff-1747-46bb-8c0d-e15201d4a148n%40groups.riscv.org.