Wiring Pulsar to duet 6HC and configuring

[Václav Musil]

Hi can you please provide specific information how to wire up and configure the pulsar on the 6HC duet 3d board. I followed the pulsar documentation, but it lacks the details how to configure the fan and pellet sensor.

Here are my specific questions:

1. What the recommended voltage for the fan? Is it ok if I plug it to Out 7 on the 6hc board with 5 volt output?

2. Can the 3.3V IO (IO_0 to IO_8) outputs on the 6HC board control solid-state relays (SSRs) for 230V heaters, or would we need to step up the control voltage to a higher level to ensure reliable operation?

3. Where to plug the pellet sensor and how to configure it?

[Technical Support]

Hi Václav Musil!

Thanks for reaching us!

Here are the details:

1. If you are talking about a fan, I guess you are using a Pulsar Atom. You can check on the wiring diagram the details for it:

2. Yes, the SSR are rated for 3.3VDC.

3. The pellet sensor can be wired to the Duet according to Duet standards, here is our wiring details: 

If you have a pellet feeding system, you can check more details here: https://docs.dyzedesign.com/pellet-feeding-system.html#what-s-in-the-box

I hope it helps!

Andy (Andréanne Poulin - She / Her ) Support Team
	100-1505 Saint-Thomas Lemoyne, Quebec, Canada, J4P 3S2
	dyzedesign.com

--
You received this message because you are subscribed to the Google Groups "DYZE DESIGN" group.
To unsubscribe from this group and stop receiving emails from it, send an email to support-dyze-de...@dyzedesign.com.
To view this discussion visit https://groups.google.com/a/dyzedesign.com/d/msgid/support-dyze-design/406fd9c8-8230-4862-a93c-51d5c292d92dn%40dyzedesign.com.