Filament sensor stopped working

[Brett Mitcheltree]

I am using the filament sensor on a duet 2 board with rrf 3 . had it working but has suddnely stopped pusing the print when it runs out of filament.

[Technical Support]

Hi Brett,

The logic output from the Sentinel is tied to the green LED, so if the LED is ON, so is the output.

Can you check if the LED is ON by mistake, when there are no filaments inside the Sentinel?

It can also be a new requirement from Duet, maybe they need a Gcode at the start of a print to enable the Sentinel sensor.

Support Team
	100-1505 Saint-Thomas Lemoyne, Quebec, Canada, J4P 3S2
	dyzedesign.com

On Wed, Mar 31, 2021 at 7:16 PM Brett Mitcheltree <blm...@gmail.com> wrote:

I am using the filament sensor on a duet 2 board with rrf 3 . had it working but has suddnely stopped pusing the print when it runs out of filament.

--
You received this message because you are subscribed to the Google Groups "DYZE DESIGN" group.
To unsubscribe from this group and stop receiving emails from it, send an email to support-dyze-de...@dyzedesign.com.
To view this discussion on the web visit https://groups.google.com/a/dyzedesign.com/d/msgid/support-dyze-design/c1db0ff2-b2d7-49ed-8dea-d4acbc2c1f9dn%40dyzedesign.com.