Fwd: Table saw motor

[Angela Reese]

The situation, per my husband:

We have a mid 70s contractor grade Craftsman 12 inch table saw.

The motor recently died. 

I've taken it to a motor repair shop and the windings are cooked and getting them rewound is nowhere near practical/affordable.

The old motor was not a belt drive (has an arbor for direct drive ) is 1 hp 230/240 volt. Attached are photos showing the motor specs and a side view.  The side view shows the four holes where it is bolted to the carriage

So far, I've not found anything that would constitute a direct replacement. 

I've expanded my search to include old delta motors as they may or may not have built my table saw for Craftsman. If anyone has suggestions on where to look or what other alternatives to check out, it would be greatly appreciated!

Thanks!

Angela (& Dave)

--

****************************************
"I disapprove of what you say, but I will defend to the death your right to say it."
  - S.G. Tallentyre, attributed to Voltaire

"Each time a man stands up for an ideal, or acts to improve the lot of others, or strikes out against injustice, he sends forth a tiny ripple of hope, and crossing each other from a million different centers of energy and daring, those ripples build a current that can sweep down the mightiest walls of oppression and resistance."

  - Robert Kennedy

[Maker Bill]

any part number on the motor or saw?

--
You received this message because you are subscribed to the Google Groups "Discuss Newsgroup" group.
To unsubscribe from this group and stop receiving emails from it, send an email to discuss+u...@champmakerspace.org.
To view this discussion visit https://groups.google.com/a/champmakerspace.org/d/msgid/discuss/CAG8nkq3eToSCAuBnKyQqkV%2BuQDL0uzmjOm98FVxpfw5QF7hOGQ%40mail.gmail.com.

[Angela Reese]

Part #62459 according to the photo

To view this discussion visit https://groups.google.com/a/champmakerspace.org/d/msgid/discuss/c5547fa3-9c88-471b-a64d-1cb71174983d%40champmakerspace.org.

[Maker Bill]

sorry looked at this on my watch :)

To view this discussion visit https://groups.google.com/a/champmakerspace.org/d/msgid/discuss/CAG8nkq2UgabXGMF7iqoOttOryk7%3Dx%3DU5ZUvWz0Qqs7EAAChJMg%40mail.gmail.com.

[Angela Reese]

Well, you clearly need a bigger watch!  

To view this discussion visit https://groups.google.com/a/champmakerspace.org/d/msgid/discuss/412b88b6-5832-493e-9ec0-5b2859c0d81b%40champmakerspace.org.