Strange Alerts

[AAron nAAs]

I've just gotten two strange alert behaviors

1) Camera A reports (via hovering over bell): 1 alerts, 1 new

When clicking on it, the timeline always jumps to 15:03, there are no detected objects in view, and the timeline shows all white.

2) Camera B shows an alert with a green timeline segment that contains a squirrel

But there's no label saying what was detected.

BTW, In the home view with 3 cameras, I was clicking the alert bells, and moving between the clips... when Camect went completely offline, and slowly came back up and enabled the camera view across 30-60 seconds.

[CamectArup]

Relative to the crash you mentioned, when did the other two behaviors occur? (i.e. Before, or after. If they were after, it might be because the alert information had not finished reloading by the time you looked.) 

[AAron nAAs]

I had already seen the two strange alerts, and was clicking around on the camera alerts in the home view.

After the Camect crash the strange alerts were still there.

Even now at 23:20, the one alert bell is still green with the same "1 alerts, 1 new" message... which still brings me to the non-green 15:03 spot on the timeline with no named objects.