how to configure a logical drive

[Luca]

Hi

I've configured 2 Logical Drive on a SCSI Controller. Three disk have a raid
5 configuration and the last 2 have Raid 1.
I install a SCO Openserver 5.0.4 with

boot : restart link="ipsraid" Sdsk=ips(0.0.0.0)
Srom=(0.0.0.0)

All works fine, but now i've only the first logical drive configurated !!!

How can i mount the second logical drive ???

(( mkdev hd for scsi disk call me about scsi id,bus,host (not for logical
drive !!!) ))

Thank's

[Tony Lawrence]

Luca wrote:

The logical drive presents itself as a physical drive.

If you look at /etc/conf/cf.d/mscsi now, you'll see one entry for your
RAID array- presented as one physical drive.

Often RAID controllers present each array as the id of its first
member, or they'll just go in sequence, first array seen as id 0, second
as 1, but yours could be different. If you were running 5.0.5 or better
you could try "sconf -v" to see what it sees, but that usually panics a
5.0.4 system.

--
Tony Lawrence
SCO/Linux Support Tips, How-To's, Tests and more: http://pcunix.com

[Tom Parsons]

Luca enscribed:

I expect this information is buried in the plethora of information IBM
supplied with the controller. If not, it is probably on their website,
although finding it can take a little time. Failing both of those and
some experimentation using Tony's suggestions, you could call the support
numbers that came with the controller.
--
==========================================================================
Tom Parsons t...@tegan.com
==========================================================================