I usually print a continuous noodle but I'm making some parts for my new
robot and there are a lot of M103's
When the plastic is turned back on, there's a delay before it arrives.
I have a feeling OOZEBANE is my target command.
I have entered a value of 5 in the EARLY STARTUP DISTANCE without much
This AM, I searched for settings and copied this script:
WindowPosition = 700+0 * *
Open File for Oozebane =
Activate Oozebane = False
After Startup Distance (millimeters): = 1.2
Early Shutdown Distance (millimeters): = 1.2
Early Startup Distance Constant (millimeters): = 20.0
Early Startup Maximum Distance (millimeters): = 1.2
First Early Startup Distance (millimeters): = 50.0
Minimum Distance for Early Startup (millimeters): = 0.0
Minimum Distance for Early Shutdown (millimeters): = 0.0
Slowdown Startup Steps (positive integer): = 1 *
I see he has 20 for startup.
Is this a good place to go for my problem?