What is your nozzle diameter?
From: firstname.lastname@example.org [mailto:email@example.com] On
Behalf Of Bill Culverhouse
Sent: Monday, October 08, 2012 3:09 PM
Subject: Re: [thingiverse] How can you make steeper overhangs
"Try setting layer height lower"
"Try switching to PLA with active cooling"
On Mon, Oct 8, 2012 at 4:52 AM, Dolf Veenvliet <maco...
Thanks guys.... but eh... "experiment" I of course already do, and the math
is well... I don't know... I wouldn't really know how to apply the math to
specific settings in the Replicator-G software that came with the Makerbot.
I was kind of hoping for "try putting setting x a bit lower (but no lower
than x) and setting b a bit higher (but in my experience no higher than y)".
On Monday, October 8, 2012 12:58:25 AM UTC+2, Ahmet Cem TURAN wrote:
SFACT calculates it as atan(width-height)/2/ height. So the round part is
excluded from the overhang calculation..
In both cases experiment...