Fwd: [diy_3d_printing_and_fabrication] Build Status Update

6 views
Skip to first unread message

Sector67 Team

unread,
Nov 7, 2011, 9:35:06 AM11/7/11
to southern-wi...@googlegroups.com
It looks like those DLP printers aren't all the difficult.  Need a silicon coated chunk of glass and a filter on a DLP projector with no lens. Only issue seems to be the cost of the resin?


Chris

---------- Forwarded message ----------
From: pzamov <pza...@yahoo.com>
Date: Mon, Nov 7, 2011 at 6:03 AM
Subject: [diy_3d_printing_and_fabrication] Build Status Update
To: diy_3d_printing...@yahoogroups.com


 

@Groups Wow! Pretty quiet! Ok, Lets shake it a little bit:

Updated the blog:

http://3dlprint.com

with first Dymax 9663 test pictures. Results are that 9663 does not stick to 100% silicone for aquariums. It does however stick to glass fairly well. Glass cleans pretty good with a utility knife and soft towel ( I would suspect with a resin thinner also ) with 97% alcohol and it is ready for another resin burn. I could move the resin on the slide glass with silicone, but on the uncoated glass slide I had to use my pliers to remove the resin ( and it removes pretty clean ). Then I take a OLFA ( utility knife ) and run the blade on the glass and finish with Alcohol 97%.

The only one from my sample pack is the 9663 that I can polymerize with the projector.

I received the Michaels Resin Color pack like robhopeless and vrsculptor. I have not tryed to dye any resin yet as I only have 30mg ( ml ) to work with.

That's it for now.
P

__._,_.___
Recent Activity:
.

__,_._,___



--
Chris Meyer
Director
Sector67

608-241-4605
http://sector67.org

2100 Winnebago St
Madison, WI  53704

Dithermaster

unread,
Nov 8, 2011, 5:09:56 PM11/8/11
to southern-wi...@googlegroups.com
Nice! And documented unlike JR's. I think it's a replacement lens, not no lens. Provided the raw material is cheap, these could replace FDM.

///d@
Reply all
Reply to author
Forward
0 new messages